Sea-Bird Electronics SBE 38 Instrukcja Użytkownika Pobierz pdf (Strona 32)

Manual revision 006 Section 4: Deploying and Operating SBE 19plus V2 SBE 19plus V2

Moored Mode

At pre-programmed intervals, the SBE 19plus V2 wakes up, samples data,

stores the data in its FLASH memory, and enters quiescent (sleep) state.

The 19plus V2 goes to sleep for a minimum of 5 seconds between each

sample. Logging is started with StartNow or StartLater, and is stopped with

Stop. If real-time data is to be transmitted (MooredTxRealTime=Y), data is

transmitted after measurements are complete for that sample and before

sampling begins for the next sample.

Example: 19plus V2 in Moored mode

Wake up 19plus V2. Set date and time to October 1, 2011 at 9:05 am. Initialize logging to overwrite previous data in

memory. Set up with 1 voltage sensor, take a sample every 120 seconds, take and average 4 measurements for each

sample, do not transmit real-time data, and output data in raw hex format. Set up pump to run for 0.5 seconds before

each sample. Set up to start logging on October 15, 2011 at 11 am. Send command to start logging at designated date

and time. After all parameters are entered, verify setup with status command. Send power-off command.

(Click Connect in Seaterm232’s Communications menu to connect and wake up.)

DATETIME=10012011090500

INITLOGGING

VOLT0=Y

SAMPLEINTERVAL=120

NCYCLES=4

MOOREDTXREALTIME=N

OUTPUTFORMAT=0

MOOREDPUMPMODE=1

STARTDATETIME=10152011110000

STARTLATER

GETCD (to verify setup)

Deploy 19plus V2. Logging starts automatically at programmed date and time.

Upon recovering 19plus V2, stop logging. Upload data in memory, in format SBE Data Processing can use.

Send power-off command.

(Click Connect in Seaterm232’s Communications menu to connect and wake up.)

STOP

(Click Upload – Seaterm232 leads you through screens to define data to be uploaded and where to store it.)

Note:

Use Stop to:

• Stop autonomous sampling

• Stop waiting to start autonomous

sampling (after Startlater has been

sent)

Once Stop is sent, the 19plus V2

accepts all commands again.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 123 124

Brak uwag

Sea-Bird Electronics SBE 38 Instrukcja Użytkownika Strona 32